When driving a large vehicle, one must first understand its characteristics: large mass and high inertia. High center of gravity and large centrifugal force; The vehicle body is long and occupies a large space. Long wheelbase and large inner wheel difference; Pneumatic braking, with a fast braking response; The steering wheel is large and its response is slower than that of the trolley. It has more than six gears and small gear clearances. In short, it is more complicated and demanding to operate than driving a small car.
Driving skills for large trucks
1. When starting, the clutch, throttle and handbrake should be accurate, especially when releasing the handbrake. When starting on an uphill slope, the clutch node should be more stable and the throttle slightly larger. However, the advantage of a large vehicle is that it has more power when starting in first gear than a small car, making it easier to start.
2. Shift gears in a timely manner and avoid dragging gears. Especially when going uphill, downshift in advance to ensure reserve power. In addition, when shifting gears, use a two-pedal clutch and add empty gas when downshifting. When going downhill, shift to a low gear and never coast in neutral.
3. When turning, make a turn in advance according to the conditions of the curve. For sharp turns, take an appropriate Angle and fully consider the inner wheel difference. That is, when making large turns, if the conditions of continuous curves permit, try to cut open turns as much as possible to reduce the influence of centrifugal force. When braking, do not apply the brakes continuously. Pay attention to the air pressure to prevent loss of control. Because pneumatic braking responds quickly, more practice is needed to master the force. The large vehicle turns left and right about 3.5 times, so you need to practice pulling the big handlebar. You can't do it like a small vehicle rubbing plates.
4. When parking or reversing, one should fully consider the vehicle's trajectory and spatial position.
5. When overtaking, choose the right moment, leave sufficient leeway, and do not make sudden turns.
Driving skills for shifting gears of large trucks at 100 meters
When shifting up, after starting, as soon as the vehicle enters the normal driving route, immediately step on the accelerator pedal to quickly increase the speed to a low range one gear higher than this. When the clutch is released and the vehicle is accelerated, if the engine and the vehicle do not shake, it is just right. If the engine and the vehicle shake, it indicates that the acceleration is too low and the speed should be increased a little more.
If the vehicle shows a rear-seat phenomenon, it indicates that the acceleration is too high and you should lift less. At this point, quickly shift the gearshift lever into a higher gear, then increase the speed. Use the same method to shift the gearshift lever step by step into the highest gear.
When downshifting, if an obstacle is found ahead and the vehicle is still traveling at a high speed when approaching a bumpy road, the brake can be used to further reduce the speed until the vehicle does not experience significant jolts when passing through the bumpy road. When using the brake to further decelerate, if the vehicle is about to shake, you can step on the clutch pedal. After decelerating, when the vehicle speed drops to the lower end of a certain gear range, shift the gear lever into that gear.
Every car will have a blind spot
If you are driving normally on the highway and notice a car following you through the rearview mirror. After a while, you find that you can't see the car from the left, right or middle rearview mirrors of your car, and there are no highway exits passing through in between. So where did this car go? In fact, this car is overtaking you near your left or right rear window, but you can't see it. This is a blind spot.
Every car has blind spots, only the sizes vary. So when we are changing lanes to overtake, before changing lanes, remember to slightly turn your head and use the corner of your eye to check through the side rear window if there are any vehicles.
Emergency handling for high-speed tire blowouts
In fact, driving on the highway is not difficult, but it is even more dangerous. Why is that? The most important skill for driving at high speed is the ability to respond to high-speed emergencies. When driving on the highway, regardless of whether there are vehicles in front or behind, always hold the steering wheel firmly with both hands. Never drive with one hand. On highways, due to the high speed of the tires, they generate heat, wear out more rapidly, and the pressure increases, making them prone to blowouts. So when driving at high speed, one must always be vigilant against tire blowouts.
In the event of a tire blowout, the correct way to handle it is to hold the steering wheel tightly with both hands and keep the vehicle slightly off-center. Keep the vehicle moving forward steadily, release the accelerator, wait until the speed drops to around 40 kilometers per hour, and then gently turn the steering wheel to pull the vehicle over to the emergency parking lane. Never rush to stop the vehicle when a tire bursts; otherwise, a rollover accident may occur. When the left tire bursts, the car will veer to the left. At this time, you should slightly turn the steering wheel to the right to keep the car from deviating from the lane. If the right tire bursts, apply some force to the left in the same direction.
Don't speed.
Everyone has read the article "Advice from a highway traffic police Officer", right? When the speed exceeds 160 kilometers per hour, the fatality rate of people involved in vehicle accidents is 100%. 120 is already very fast. No matter how urgent the matter is, it is not as important as life safety. When driving, pay special attention to the elderly and children. Especially in the urban-rural fringe areas, on the lanes where people and vehicles travel together. Many elderly people will suddenly cross the road without any warning.
Have a broad vision
During the process, observe the movement of all objects in front, back, left and right and predict their trajectories. This might be something many people can't achieve, but we should strive to do it. Only when the possible trajectory route is predicted can emergency response measures be well prepared. It's best to scan the three rearview mirrors every few dozen seconds while driving. Also, try to see the road conditions in front of the vehicle through the glass of the car in front as clearly as possible. In short, the wider the field of vision, the better.
Pay attention to the hints others give you
Sometimes when your car has a problem, you may not be aware of it yourself, but the vehicles traveling with you can notice it. They might alert you through their eyes, honking or lights. So when you are driving and encounter someone honking or flashing lights at you for no reason or pointing at you, the first thing you should think about is whether there is something wrong with your car. It's better to stop in a safe place to check before continuing.






