Home > Blog > Content

Proper Use of Tires: Key Considerations

Jan 09, 2026

1. Prevent Overloading and Tire Blowouts
There are many reasons for overloading, such as uneven loading, traveling on poor roads, inconsistent hardness of leaf springs, one tire being underinflated or both tires being overinflated, the effect of centrifugal force during turning, etc. Overloading of the entire vehicle will cause the tires to be overloaded. Measures must be taken to prevent tire blowouts due to overloading.
II. Anti-deflation Tire Technology
Whether the tire pressure is standard is an important factor for protecting the tires. Before getting on the vehicle, during driving, and after parking, it is necessary to check the tire pressure and the reasons for the low pressure, and eliminate them to prevent tire damage due to low pressure.
III. Preventing Damage to Tires from Iron Nails and Sharp Objects
When vehicles enter or exit factories, construction sites or construction sections, measures should be taken to prevent bolts, nails, sharp stones and other debris from damaging the tires. When driving, one should choose the road surface and try to avoid obstacles. After passing through, the vehicle should be stopped for inspection.
4. Anti-oil, acid and alkali erosion tires
Oil stains (such as gasoline, engine oil, lubricating grease, etc.) and acidic or alkaline chemical substances can cause chemical changes in rubber, making it sticky and swollen, and reducing its toughness, elasticity and wear resistance. One should try to avoid contact with these substances.
V. Preventing Component Damage to Tires
If the car chassis malfunctions or is improperly adjusted and repaired, it will cause abnormal wear and damage to the tires.

Prohibited Uses:
1. Avoid going too fast at the beginning.
The car started too forcefully, causing significant circumferential deformation of the tires and slippage on the tread surface. The tires were severely worn. Especially in cold regions, due to the low temperature, the physical and mechanical properties of the tires will deteriorate, the brittleness of the rubber will increase, and the elasticity will decrease. Therefore, when starting, the clutch should be raised slowly to allow the car to start naturally and smoothly. During the first 20 to 30 kilometers of travel, the speed should be controlled within 10 km/h to allow the tire temperature to rise before normal driving. If the vehicle has been parked on an icy surface for a period of time, the part of the tire in contact with the ground may be frozen. When starting, one should be particularly careful to prevent the tread from being torn or causing the tread to separate from the tire body.
2. Avoid sudden braking
When a car frequently accelerates and decelerates during driving, it will accelerate the wear of the tires. If emergency braking is frequently used, the wear will be even more severe. Especially for cars that are fully loaded and traveling at high speeds, during emergency braking, the tires will stop rolling and skid, causing severe wear on the local tire surface. At the same time, due to excessive and rapid circumferential deformation, it may cause the tire surface to separate from the tire body. Therefore, when changing directions, going downhill, crossing roads, and on sections with complex conditions, the car should slow down to avoid emergency braking and prevent unnecessary tire wear.
III. Avoid Driving at High Speed
"Moderate speed driving has many benefits, including safety, fuel efficiency, and cost savings." This makes sense and indicates that driving too fast can cause many problems. Just take tires as an example. When driving at high speed, the impact load, centrifugal force, and the number of times the tires come into contact with the ground per unit time increase significantly, causing the tires to deform frequently, intensifying internal friction and friction with the ground, and significantly raising the temperature. This not only accelerates the wear of the tire tread but also causes the tire body's cord fabric layer to peel off and burst, etc. According to tests, when the driving speed increases from 50 km/h to 65 km/h, the tire's service life decreases by 22%. If a car turns while driving at high speed, the tires will skid under the action of lateral force, causing excessive deformation of the tire side and accelerating the wear of the tire tread. Therefore, in general, it is advisable to maintain moderate speed driving. Even when the task is urgent and the vehicle speed needs to be increased, one should pay attention to correct operation to prevent damage to the car and tires and avoid traffic accidents.
Four. Avoid not choosing a path or choosing the wrong one.
Cars will cause tire wear under various road conditions, but different roads cause significantly different levels of tire wear. Therefore, when choosing a road, one should pay more attention.
V. Avoid excessive or insufficient fetal pressure
The normal tire pressure refers to the specified inflation pressure for the front and rear wheels of various vehicle models as stated in the vehicle's user manual, and it is not the maximum inflation pressure marked on the tire. Some people say, "Pressure is the lifeblood of the tire." This statement has some validity. Because only by maintaining the normal tire pressure regularly can the normal deformation of the tire during operation be ensured, the tire's performance be fully exerted, and early damage be avoided. If the tire inflation pressure is too high or too low, it will cause serious harm to the tire.
Six. Avoid Overloading the Vehicle
Tire overloading is usually caused by overloading of the vehicle, unreasonable loading of materials, displacement of materials during vehicle movement, and improper selection and installation of tires. When tires are overloaded and driven, the load and stress they bear increase, causing the deformation of the tires to become greater, especially the deformation of the tire sidewalls becomes more significant, leading to increased wear on the tire shoulders. The internal friction of the tire body material and the mechanical friction between components cause the tire temperature to rise, and the tire cord layer is prone to delamination, accelerating the damage of the tires.
In conclusion, the more the vehicle is overloaded, the shorter its service life will be. According to relevant data, when the tire load exceeds 20%, the mileage will decrease by 35%; when it exceeds 50%, it will decrease by 59%; and when it is overloaded by double the normal amount, it will decrease by more than 80%.

Send Inquiry