Home > Blog > Content

Tips for reinforcing and replacing excavator bucket teeth

Nov 28, 2025

I. Techniques for Reinforcing Bucket Teeth

Welding wear-resistant layer

Applicable scenarios: When the tooth tip is slightly worn but not penetrated.
Method: Overlay welding with wear-resistant electrodes (such as D608) on the surface of the tooth tip to form a hardened layer 3-5mm thick, with a focus on reinforcing the leading edge and the easily worn areas on both sides.

Note: Preheat the tooth body to 150-200℃ before welding to avoid cracks. Slow cooling after welding to prevent stress concentration.

Install a gear sleeve

Structure: The gear sleeve is an independent wear-resistant part, placed outside the tooth tip. Once worn, only the gear sleeve needs to be replaced.
Installation: Select a tooth sleeve that matches the size of the tooth tip, and press it in with a hydraulic press to ensure that the gap between the tooth sleeve and the tooth tip is ≤0.5mm.

Advantages: Extend the lifespan of tooth tips by 30% to 50% and reduce the overall replacement cost.

Select high-strength alloy teeth

Material: Prefer tooth tips containing alloy elements such as tungsten and molybdenum (such as H20K alloy), with a hardness of up to HRC55-60.
Effect: Compared with ordinary manganese steel teeth, its wear resistance is increased by 2 to 3 times, making it suitable for harsh working conditions such as rocks and frozen soil.

Ii. Steps for Replacing Bucket Teeth

Prepare the tools

Tool list: Pin shaft puller, hydraulic press-fitting machine, sledgehammer, copper rod, grease, new gear and matching pin shafts.
Disassemble the old teeth

Step: Loosen the fixing bolts or retaining rings at both ends of the shaft.
Put the pin shaft puller onto the pin shaft and apply pressure slowly with a hydraulic pump until the pin shaft comes out.

If the pin shaft is rusted, you can use a sledgehammer with a copper rod to strike one end of the pin shaft, and at the same time use a puller for assistance.

Remove the old teeth and clean the debris inside the tooth seat.

Install new teeth

Step: Align the new teeth with the tooth seat and ensure that the pin holes are fully aligned.
Apply grease to the surface of the pin shaft to reduce wear.

Press the pin shaft in with a hydraulic press machine until the exposed lengths at both ends are the same.

Install the fixing bolts or retaining rings, and the tightening torque should meet the requirements of the manual (usually 200-300N·m).

Iii. Key Points to Note

Safe operation: When replacing, the bucket must be fixed to prevent sliding. Wear goggles and gloves to prevent metal debris from splashing.

Model matching: The new tooth model must be consistent with the original one; otherwise, it may lead to unstable installation or accelerated wear.

Regular inspection: It is recommended to check the wear of the teeth every 50 hours. When the wear of the tooth length exceeds 40% of the original length, replacement is necessary.

Working condition adaptation: Select the tooth type (such as rock teeth, earthwork teeth) based on the construction object to avoid "small teeth for large use" or "large teeth for small use".

When operating in granite mines, choosing H20K alloy teeth and installing tooth sleeves can extend the tip life of the teeth from 200 hours to 500 hours and reduce the cost of a single tooth by 40%.

Send Inquiry