Home > Blog > Content

Why doesn't the Sany truck-mounted pump operate

Nov 03, 2025

The failure of the Sany truck-mounted pump to operate may be caused by multiple reasons. The following are some common causes and troubleshooting methods:

Power system issue

Engine failure: Check whether the engine can start and operate normally. If the engine fails to start or operates unstably, it may cause the on-board pump to fail to work properly. The troubleshooting methods include checking the fuel supply, ignition system, engine oil, etc.
Power transmission failure: Confirm whether the process of power transmission from the engine to the hydraulic pump is normal. Check whether the drive belt, couplings and other components are damaged or loose.

Hydraulic system issues

Insufficient or contaminated hydraulic oil: Hydraulic oil is the key medium for the operation of vehicle-mounted pumps. If the hydraulic oil is insufficient or contaminated, it will affect the normal operation of the system. Check the oil level and quality of the hydraulic oil. Replace the hydraulic oil and clean the hydraulic system if necessary.
Hydraulic pump failure: The hydraulic pump is the core component that generates hydraulic power. If the hydraulic pump is damaged or severely worn, it will result in the inability to establish sufficient pressure. Check the working condition of the hydraulic pump and carry out maintenance or replacement if necessary.

Hydraulic valve failure: The hydraulic valve controls the flow direction and pressure of the hydraulic oil. If the hydraulic valve is stuck or damaged, it will affect the normal operation of the system. Check the working condition of the hydraulic valve and clean or replace the faulty valves.

Electrical system problem

Control circuit failure: The electrical control system of the on-board pump is responsible for the transmission and execution of instructions. If the control circuit malfunctions, such as an open circuit, short circuit or poor contact, it will cause the equipment to be unable to respond to operation instructions. Inspect the electrical circuits and connectors, and repair or replace damaged components.
Sensor failure: Sensors are used to monitor the operating status of equipment. If the sensor is damaged or the signal is abnormal, it may cause the control system to misjudge. Check the readings and working status of the sensor, and calibrate or replace it if necessary.

Pumping system problem

Pumping pipeline blockage: If the pumping pipeline is blocked by concrete or other materials, it will result in the inability to pump normally. Inspect the pumping pipeline and clear any blockages.
Wear of pumping components: After long-term use, pumping components such as the pump chamber, eyeglass plate, and cutting ring may be severely worn, affecting the pumping efficiency. Check the wear and tear of these components and replace them if necessary.

Operation or setting issues:

Improper operation: Incorrect operation methods may cause the equipment to fail to work properly. Ensure that the operators are familiar with the operating procedures of the equipment and operate it in accordance with the correct steps.
Parameter setting error: Check whether the parameter Settings of the equipment, such as pumping pressure and displacement, meet the actual requirements. Incorrect parameter Settings may cause the equipment to fail to pump normally.

Send Inquiry